Instructions / Assembly

14
Troubleshooting
Problem Possible Cause Solution
The fireplace does
not operate.
The power light is ON but
the flame effect is not
visible.
There is excessivee
noise when the heater is
operating.
The heater is not
operating.
□ The fireplace is not plugged in.
□ A circuit breaker is tripped or a fuse
blown.
□ The ON/OFF switch is defective.
□ There is loose wiring.
□ The fireplace is not operating
correctly.
□ There are loose light bulb(s).
□ There are burnt out light bulb(s).
□ The fan is defective.
□ The heater assembly is defective.
□ The fireplace is not operating
correctly.
□ The heater switch is defective.
□ The heater assembly is defective.
□ There is loose wiring.
□ The vents are dirty or clogged.
□ Make sure the fireplace is plugged in
to a standard 120V outlet.
□ Check additional appliances on the
circuit; ideally the fireplace should be
on a dedicated 15-amp circuit.
□ Call customer service.
□ Call customer service.
□ Refer to the operating instructions.
□ Tighten the light bulb(s).
□ Replace the light bulb(s).
□ Call customer service.
□ Call customer service.
□ Refer to the operating instructions.
□ Call customer service.
□ Call customer service.
□ Call customer service.
□ Unplug the unit. Clear the vent area of
dust and debris. Wait ten minutes, plug
the unit in again and turn on the heater.
If you have any questions regarding the product, please call Hampton Bay Customer Service, 855-HD-HAMPTON, 8 a.m. – 6 p.m. EST,
Monday – Friday.
Part Description Part #
1 Back Panel EF237916501AC
2 Flame Panel EF237916502AC
3 Glass EF237916503AC
4 Screen EF237916504AC
5 Front Decorative Panel EF237916505AC
6 Front Panel EF237916506AC-14
7 Left Brick Side Panel EF237916507AC
8
9
10
11
12
13
14
15
Right Brick Side Panel
Top Panel
Remote Control
Main Board (PCB)
Logset
Flame Reflector
Control Panel
Control Panel Circuit Board
EF237916508AC
EF237916509AC
EF33510AS
EF237916510AC-14
EF237916511AC
EF237916512AC
EF237916513AC-14
EF237916514AC