Installation Guide

Assembly - Assembling the Fan Without the Light Kit

Installing the bulbs and attaching

the glass bowl

□ Remove the rubber washer (P), hex nut (Q), bottom cover (R),

and nial (S) from the threaded nipple of the light kit tter

assembly (F).

□ With power off, install the three LED light bulbs, (9.5-Watt

maximum included) (L) by screwing them into the light bulb

sockets.

□ Position the glass bowl (I) over the threaded nipple.

□ Re-install the rubber washer (P), hex nut (Q), and bottom

cover (R) to the threaded nipple to secure the glass shade

properly.

□ Re-install and tighten the nial nut (S).

CAUTION: Do not over tighten the hex nut. Overtightening the

hex nut may cause the glass to break.

Assembly - Attaching the Lights (continued)

Assembling the fan without the

light kit

□ Remove the three mounting screws (SS) on the

switch cup cover of the light kit tter assembly (F).

□ In order to use the fan without the light kit, remove

the switch cup cover (TT) from the top of the light kit

tter assembly (F) by removing the center hex nut in-

side the switch cup cover, and then thread the switch

cup cover (TT) off of the threaded nipple on the top of

the light kit tter assembly (F).

□ Press the plastic plug (GG) (provided) into the center

hole of the switch cup cover (TT).

□ Position the switch cup cover (TT) onto the switch

cup (1) of fan motor assembly and reinstall the light

kit mounting screws (SS).