Installation Guide

17
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
USING THE REMOTE CONTROL
□ Remove the protective coating from the battery.
□ Remove the battery cover from the remote control.
□ Install the 9-Volt battery (included) into the battery
compartment of the remote control (K).
□ Replace the battery cover on the remote control.
□ Press the desired button on the remote control (K) to operate
the fan:
• “High” button: Press to turn the fan on and set the fan speed
to high.
• “Med” button: Press to turn the fan on and set the fan speed
to medium.
• “Low” button: Press to turn the fan on and set the fan speed
to low.
• Power button (UU): Press to turn the fan off.
• Light button (VV): Press and release immediately to turn the
light on or off.
Your fan is equipped with a remote control to operate the fan speed
and lights of your new ceiling fan.
The speed setting for warm or cool weather depends on factors such
as the room size, ceiling height, number of fans and so on.
The fan is shipped from the factory with the reversing switch
positioned to circulate air downward. If airow is desired in the
opposite direction, turn your fan off and wait for the blades to stop
turning, then slide the reversing switch (YY) (located in switch cup) to
the opposite position, and turn the fan on again. The fan blades will
turn in the opposite direction and reverse airow.
A. Warm weather - (Forward) A downward airow creates a cooling
effect. This allows you to set your air conditioner on a higher setting
without affecting your comfort.
B. Cool weather - (Reverse) An upward airow moves warm air off of
the ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
NOTE: This remote is equipped with a 16-code combination. To
prevent possible interference from or to other remote units, such
as garage door openers, car alarms, or security systems, change
the combination code but be sure that the code on both the remote
control and receiver in the fan are the same.
OPERATING YOUR FAN
Operation
A. Warm weather
B. Cool weather
YY
YY
LIGHT ON/OFF
LOW
MED
HIGH
FAN OFF
TM
K
UU: Power OFF
VV: Light ON/OFF
ON/High
ON/Medium
ON/Low
Power Indicator will light
when buttons are pushed