Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ceiling Loop with Chain (#12) 1 Quick Link (#9) 1 Lock Collar (#10) 1 Canopy (#11)
1 Nipple (#13) 1 Lock Washer (#17) 1 Hex Nut (#18)
1 Ground Screw (#14) 2 outlet Box Screw (#15) 1 Crossbar (#16) 3 Wire Connectors (#19)
INSTALLATION INSTRUCTIONS:
1. Thread Nipple (#13) into Ceiling Loop (#12) until snug.
2. Thread other end of Nipple with Loop attached into crossbar (#16) until snug.
3. Place Lock Washer (#17) over end of Nipple protruding through crossbar and thread
Hex Nut (#18) onto nipple until tight.
4. Take the crossbar assembly and mount to ceiling outlet box (#20) with outlet box
screws (#15). Tighten screws securely with screwdriver.
5. By measuring determine correct number of links needed for proper hanging height.
Use a pair of pliers to open one end link of the chain and discard un- wanted chain.
(Don’t disregard the Quick Link linked at the end of Chain.)
6. Slip Canopy (#11) and Lock Collar (#10) through over the Ceiling Loop with Chain
(#12), then connect the other end of Ceiling Loop with Chain (#12) to Fixture Loop
(#1) by using Quick Link (#9).
7. Lace the fixture’s wires through the chain links and pull until taut. Feed the fixture
wires through the Lock Collar, Canopy, Ceiling Loop with chain and Nipple and pull
until taut.
8. Connect the ribbed wire from the fixture to the Neutral wire from the outlet box (#20)
and the smooth wire from the fixture to the hot wire from the outlet box (#20). Cover
the two wire connections using the two provided wire connectors (#19). Wrap the
two wire connections with electrical tape for a more secure connection. If your outlet
box has a ground wire (green or bare copper), connect fixture’s ground wire to it
using the wire connector (#19). Otherwise connect the copper ground from the
fixture to Ground screw (#14) on the Crossbar (#16). Note: If you have electrical
questions, consult your local electrical code for approved grounding methods.
9. Tuck these wire connections neatly into the ceiling outlet box and then raise the
canopy all the way to the ceiling. Raise the Lock Collar and thread onto Ceiling
Loop protruding through Canopy.
10. Install Light bulbs in accordance with the fixture’s specifications. (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING)
11. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.