Installation Guide

Light plate
Bulb
Glass shade
Figure 18
WARNING: Shut off the power supply before removing or replacing lamp.
In handling of halogen bulb, care should be taken not to touch it with your
bare hands. Oil residue will shorten the life of the halogen bulb. If you
accidentally come into contact, wipe thoroughly with a clean, lint-free,
cotton cloth. Allow the bulb to cool off for 10 minutes before changing the
bulb. Use light bulb in accordance with the fan's specification. TO
REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM
WATTAGE RATING.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be
equipped with a 190 watt limiting device. If lamping exceeds 190 watts,
the ceiling fan's light kit will shut off automatically.
Step 1. Install 100W halogen bulb (included). (Fig. 18).
Step 2. Raise glass shade up against the light plate and secure it to fan by
twisting glass clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 18)
10. Installing the light bulb and glass shade