Installation Guide

Outlet box
Hanger bracket
Cross pin
Hanger
ball
Downrod
Downrod
Supply
wires
Figure 5
Figure 7
Figure 8
Figure 6
Figure 9
Figure 10
Registration
slot
Downrod
Canopy
Canopy cover
Set screws
Hitch pin
Lock pin
Hitch
pin
Lock
pin
Set
screws
Hanger ball
Coupling cover
REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1. Secure the hanger bracket to the
ceiling outlet box using screws and lock
washers included with your outlet box.
(Fig.5)
Step 2. Loosen the two set screws and
remove the hitch pin and lock pin in the
top coupling of the motor assembly.
(Fig.6)
Step 3. Remove hanger ball from
downrod assembly by loosening set
screw, removing the cross pin, and
sliding ball off rod. (Fig.7)
Step 4. Carefully feed fan wires up
through the downrod. (Fig. 8) Thread
the rod into the coupling. Next line up
holes and replace lock pin and hitch pin.
Tighten set screws.
Step 5. Slip coupling cover, canopy
cover, and canopy onto downrod. (Fig.9)
Carefully reinstall hanger ball onto rod
being sure that cross pin is in correct
position, set screws are tighten and
wires are not twisted.
Step 6. Now lift motor assembly into
position and place hanger ball into hanger
bracket. Rotate until the check groove has
dropped into the registration slot and seats
firmly. (Fig. 10) Rod should not rotate if
this is done correctly.
Hanging the Fan 4.