Installation Guide

6. Finishing the
Installation
Step 1. Tuck connections neatly into
ceiling outlet box.
Step 2. Slide the canopy up to ceiling and
over the two crews on hanger bracket.
Rotate canopy clockwise. Next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
clockwise until tight. Note: adjust the
canopy screws as necessary until the
canopy and canopy cover are snug. (Fig. 14)
Figure 14
Outlet box
Hanger
bracket
Hanger
ball
Canopy
Canopy
cover
7. Blade Installation
Step 1. Attach the fan blades to the blade
holders using the screws and rubber washers
provided, tighten screws securely. (Fig. 15)
Step 2. Rotate motor so that the screw holes
are revealed through the opening on switch
cap plate. Align motor holes to blade holders
and secure with screws provided, tighten
screws securely. (Fig. 15)
Screws
Blade holders
Blades
Screws
Rubber
washer
Slot
Tab
Figure 15
Figure 13
White (neutral)
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
Ground
(green)
(Connect to
ground wire on
hanger bracket
if no house
ground wire
exists.)
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Receiver
Blue ("for light")
Blue (light)
Black (motor)
Fan