Installation Guide

13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Attaching the blade brackets to
the motor
Attaching the blades
1 2
□ Mount the fan blade (F) to the blade bracket (G) by aligning
the three key-slot holes in the blade (F) with the three posts
on the top of the blade bracket (G).
□ Hold the blade (F) with both hands close to the blade bracket
(G) and press the blade (F) down rmly. Ensure the key-slot
holes are properly seated on the blade bracket (G) posts.
□ While still holding the blade (F) down with both hands, rmly
slide the blade (F) away from the fan-motor (D) housing until
the blade (F) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(G) springs upward and butts against the edge of the blade
(F), indicating a secure connection.
□ Visually inspect the top of the blade bracket (G) to ensure the
locking mechanism is securely in place.
□ Repeat this procedure for the remaining blades (F).
D
G
F
□ Carefully unhook the fan from the slide-on mounting bracket
(A) and align the locking slots of the canopy (C) with the two
screws in the slide-on mounting bracket (A). Push up to engage
the slots and turn clockwise to lock the canopy (C) in place.
□ Immediately tighten the two mounting screws rmly.
□ Install the remaining two mounting screws into the holes in the
canopy (C) and tighten rmly.
□ Install the decorative canopy ring (L) by aligning the ring’s slots
with the screws in the canopy (C). Rotate the canopy ring (L)
counterclockwise to lock it in place.
WARNING: The locking slots of the canopy are provided only as an
aid to mounting. Do not leave the fan assembly unattended until
all four canopy screws are engaged and rmly tightened.
D
C
A
JJ
L
NOTE: Your fan features revolutionary advancements for
quick and easy blade installation.
NOTE: Your fan blades are reversible. Select the blade side
nish which best accentuates your decor.
□ Fasten the blade bracket (G) to the fan-motor (D) by insert-
ing the alignment post into the slot on the bottom of the
fan-motor (D) and tightening the fan-motor screws.
□ The fan-motor screws are pre-attached to the blade
bracket (G). Repeat this procedure for the remaining four
blade brackets (G).
D
G
Mounting the fan-motor assembly
(close-to-ceiling mount)
9
Assembly - Hanging the Fan (continued)
Assembly - Attaching the Fan Blades