Instructions / Assembly

9
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Hanging the fan
2
A
B
D
C
A
C
D
L
XX
Close to ceiling mount. Standard mount.
L
XX
Assembly - Hanging the Fan (continued)
□ Carefully lift the fan-motor assembly (D) up to the slide-on
mounting bracket (A).
□ Insert the ball portion of the ball/downrod assembly into the
socket of the slide-on mounting bracket.
□ Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket aligned with the
slot in the ball.
□ If using close-to-ceiling mounting, hang the fan on the hook
provided by utilizing one of the holes at the outer rim of the
ceiling canopy (C).
WARNING: The hook (XX) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (XX) breaking, causing the fan to fall.
The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (XX) it is
critical that you use one of the non-slotted (round) holes in
the canopy (C).
3
NOTE: The frequencies on your receiver and remote
control have been preset at the factory. Before installing
the receiver, make sure the dip switches on the receiver
and remote control are set to the same frequency. The dip
switches on the remote control are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place, as this will damage the
remote control. Dispose of used batteries properly and keep
batteries out of the reach of children.
Setting the code on the remote control
and receiver
J
K
1 2 3 4
ON
DIP
□ Remove the remote control (J) battery cover by pressing
rmly on the arrow and sliding the cover off.
□ Slide the dip switches to your choice of either up or down.
The factory setting is up.
□ Slide the dip switches on the receiver (K) to the same
position as set on the remote control (J).
NOTE: The switch marked ON/DIM controls the dimming
function of the lights: If using non-dimmable bulbs, use a
ballpoint pen or small screwdriver to set the switch to ON to
disable the dimming function. If using dimmable bulbs, set
the switch to DIM to enable the dimming function.
□ Remove the protective coating from the battery.
□ Install the 12-Volt battery (included) into the battery
compartment of the remote control (J).
□ Replace the battery cover on the remote control (J).