Installation Guide

4.
Hanging the Fan
REMEMBER to turn off the pow-
er. Follow the steps below to hang your
fan properly.
1. Securely attach the mounting plate to
the outlet box using the two screws sup-
plied with the outlet box (Figure 4). Pull
the black, white and ground wires out of
the outlet box and through the hole in the
mounting plate and lay them to the side.
2. Carefully lift the fan motor assembly and
engage the slot in the motor bracket with
the hook on the mounting plate so that it
is securely suspended (Figure 5). Then
connect the wiring to your fan according
to the section “Making the Electrical Con-
nections”.
3. Once wiring is completed, lift the motor
bracket so that the threaded studs on the
mounting plate protrude through the slots
in the motor bracket (Figure 5). Securely
tighten the three 1/4” locknuts (supplied)
onto the threaded studs, then try to shake
the motor bracket to ensure that the assem-
bly is tight (Figure 6).
Fan Motor
Assembly
Mounting
Plate
Motor
Bracket
Supply
Wire Lead
Threaded
Studs
Figure 4
Figure 5
Figure 6
FOR BETTER FAN PERFORMANCE, MAKE SURE
THE MOUNTING PLATE IS LEVEL. ADDITIONAL
WASHERS (NOT INCLUDED) MAY BE NEEDED
TO INSERT BETWEEN THE OUTLET BOX AND
MOUNTING PLATE (FIGURE 4).