Installation Guide

9.
Figure 16
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
Check that all blades are securely mounted 1.
to the blade brackets with the locking mech-
anisms engaged.
Make sure the blade brackets are not bent 2.
or out of position and ensure the blade tips
are even. Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable by
carefully following the instructions included
in the kit.
Attaching the Light
Fixture/Glass Shades
CAUTION - To reduce the risk of electric
shock, disconnect the electrical supply circuit
to the fan before installing the light xture.
Loosen the three serrated head screws on 1.
the switch cup cover of the light kit tter
(Figure 16).
Connect the wires from the light kit tter 2.
to the wires from the switch cup of the fan
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
motor assembly by connecting the molded
adaptor plugs together (blue to black, white
to white). Carefully tuck all wires and splic-
es into the switch cup.
Align the three serrated head screws on the 3.
switch cup cover of the light kit tter with
the three key slots in the switch cup. Make
sure the notch in the switch cup cover of the
light kit tter clears the reversing switch in
the switch cup. Position the light kit tter
on the switch cup and turn it clockwise un-
til it locks. Tighten the three serrated head
screws that were loosened in step 1 to se-
cure the light kit tter (Figure 16).
Remove the rubber washer, hex nut, bottom 4.
cover and the nial from the light kit tter
(Figure 17).
With power off, install the two uorescent 5.
bulbs (Max. 14W, included) by screwing
into the light bulb sockets.
Position the glass bowl over the threaded 6.
nipple and pass the fan switch chain through
the side hole in the glass bowl.
Re-install the rubber washer and hex nut to 7.
the threaded nipple of the light kit tter to
secure the glass bowl properly.
Re-install the bottom cover and nial and 8.
nger tighten the nial.
CAUTION - Be sure that the fan switch chain
does not make contact with the light bulbs.