Installation Guide

Fan Without Light Kit
In order to use the fan without the light kit, 1.
remove the switch cup cover from the top
of the light kit tter by removing the cen-
ter hex nut inside the switch cup cover, and
then thread the switch cup cover off of the
threaded nipple on the top of the light kit t-
ter. Remove three serrated head screws,
Press the plastic plug (provided) into the 2.
center hole of the switch cup cover.
Align the three screw holes in the switch cup 3.
cover with the three key slots in the switch
cup. Make sure the notch in the switch cup
cover clears the reversing switch in the
switch cup (refer to gure 16 on page 9).
Position the switch cup cover onto the 4.
switch cup and install the three serrated head
screws that were removed in step 1. Turn the
switch cup cover clockwise until it locks and
tighten the three serrated head screws.
YOUR FAN/SWITCH CUP COVER MAY NOT LOOK
EXACTLY LIKE THE ILLUSTRATION, HOWEVER
THE INSTALLATION IS THE SAME.
10.
Figure 17
Figure 18