Installation Guide

Standard Ceiling Mounting
Loosen the 2 screws in the collar on the 1.
top of the motor assembly
Remove the canopy ring from the canopy 2.
by turning the ring to the right until it un-
locks (Figure 6).
4.
Hanging the Fan
REMEMBER to turn off the pow-
er. Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
ball and socket mounting, and the “close-to-
ceiling” mounting. The “close-to-ceiling”
mounting is recommended in rooms with
less than 8-foot ceilings or in areas where
additional space is desired from the oor
to the fan blades. When using standard
downrod installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 12 inches. The “close-to-ceil-
ing” installation reduces the distance from
the ceiling to the bottom of the fan blades to
approximately 8 inches.
Once you have decided which ceiling
installation you will use, proceed with the
following instructions. Where necessary,
each section of the instructions will note the
different procedures to follow for the two types
of installation.
Figure 6
Figure 7
Figure 5
Remove the mounting plate from the 3.
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting plate (Figure 7).
Attaching the Blade
Bracket
IMPORTANT - REMOVE THE RUBBER
MOTOR STOPS ON THE BOTTOM OF
THE FAN MOTOR ASSEMBLY BEFORE
INSTALLING THE BLADE BRACKET/
BLADES OR TESTING THE MOTOR.
Your fan comes packaged with four blade brack-
ets pre-installed in the fan, motor assembly and
one separate blade bracket in the box. Install the
separate blade bracket to the fan motor assem-
bly by inserting the alignment post into the slot
on the bottom of the motor and tightening the
blade bracket screws and lockwashers. Please
note that the blade bracket screws and lock-
washers are pre-installed into the blade bracket
(Figure 5).
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. MAKE
SURE THE MOUNTING BRACKET SLOTS ARE
ON THE LOWER SIDE BY SLIDING THE MOUNT-
ING BRACKET FROM THE TOP DOWN.