Installation Guide

6.
WHEN MOUNTING ON A SLOPED CEILING,
MAKE SURE THE MOUNTING PLATE SLOTS
ARE ON THE LOWER SIDE BY SLIDING THE
MOUNTING PLATE FROM THE TOP DOWN.
Installing Fan to
the Outlet Box
Pass the 120-volt supply wires through the 1.
center hole in the ceiling mounting bracket
as shown in Figure 8.
Attach the ceiling mounting plate on the out-2.
let box by sliding the mounting plate over
the two screws provided with the outlet box.
When using close-to-ceiling mounting, it is
important that the mounting plate be level.
If necessary, use leveling washers (not in-
cluded) between the mounting bracket and
the outlet box. Note that the at side of the
mounting bracket is toward the outlet box
(Figure 8).
Securely tighten the two mounting screws.3.
Carefully lift the assembly up to the ceil-4.
ing mounting plate. If using Close-to-
Ceiling mounting, hang the fan on the
hook provided by utilizing one of the
holes at the outer rim of the ceiling canopy
(Figure 12). If using standard mounting, seat
the hanger ball in the mounting plate socket.
Make sure the tab on the mounting bracket
socket is properly seated in the groove in the
hanger ball (Figure 12).
Figure 12
THE HOOK AS SHOWN IN FIGURE 12 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIRING.
FAILURE TO HANG AS SHOWN IN FIGURE 12
MAY RESULT IN HOOK BREAKING, CAUSING
THE FAN TO FALL. HOOK MUST PASS FROM
INSIDE TO OUTSIDE OF CANOPY.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your
fan installed by a licensed electrician. Fol-
low the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan.
Secure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
Figure 10
Figure 11
Align the mounting holes with the holes 6.
in the motor and fasten, using the three
screws and lock-washers removed in step 4
(Figure 11).
Tighten the mounting screws securely.7.
FAILURE TO PROPERLY INSTALL SET SCREWS
IN STEP 7 COULD RESULT IN FAN LOOSENING
AND POSSIBLY FALLING.