Installation Guide

7.
EACH WIRE NUT (WIRE CONNECTOR) SUP-
PLIED WITH THIS FAN IS DESIGNED TO ACCEPT
UP TO ONE 12 GAUGE HOUSE WIRE AND TWO
WIRES FROM THE FAN. IF YOU HAVE LARGER
THAN 12 GAUGE HOUSE WIRING OR MORE
THAN ONE HOUSE WIRE TO CONNECT TO THE
FAN WIRING, CONSULT AN ELECTRICIAN FOR
THE PROPER SIZE WIRE NUTS TO USE.
Figure 13
CHECK TO SEE THAT ALL CONNECTIONS ARE
TIGHT, INCLUDING GROUND, AND THAT NO
BARE WIRE IS VISIBLE AT THE WIRE NUTS, EX-
CEPT FOR THE GROUND WIRE.
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL
BE UL LISTED AND MARKED SUITABLE FOR
USE WITH THIS FAN.
Connect the two green fan ground wires lo-1.
cated on the downrod and mounting plate
to the household ground wire. When using
Close-to-Ceiling mounting, there is only
one green ground wire from the ceiling
mounting plate since the ball/downrod as-
sembly is not used.
Connect the fan light supply (blue) wire to the 2.
fan supply (black) wire to the black house-
hold supply wire as shown in gure 13.
Connect the neutral fan (white) wire to the 3.
white neutral household wire.
After connecting the wires, spread them 4.
apart so that the green and white wires are
on side of the outlet box and the black wire
is on the other side.
Turn the wire connecting nuts upward and 5.
push the wiring into the outlet box.
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
Align the locking slots of the ceiling canopy 1.
with the two screws in the mounting bracket.
Push up to engage the slots and turn clock-
wise to lock in place. Immediately tighten
the two mounting screws rmly.
Install the remaining two mounting 2.
screws into the holes in the canopy and
tighten rmly.
Install the decorative canopy ring by align-3.
ing the ring’s slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
You may now proceed to attaching the 4.
fan blades.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE BOT-
TOM OF THE MOUNTING PLATE MUST REST IN
THE GROOVE OF THE HANGER BALL. FAILURE
TO PROPERLY SEAT THE TAB IN THE GROOVE
COULD CAUSE DAMAGE TO WIRING.