Instructions / Assembly

Assembly step 7
Lantern
Regulator
M6 Bolt
(F)
M6 Washer
(E)
Check for Leak
Your patio heater has been checked at all
factory connections for leakage. To check the
connection at the gas hose/regulator/cylinder
1. Make leakage solution by mixing 50% water with
50% liquid dish soap.
2. Brush several drops of the solution onto the gas
hose/regulator/cylinder and hose connection
3. Turn on the gas cylinder valve. Inspect the
connections and look for bubbles
4. If no bubbles appear the connection is safe
5. If bubbles appear there is leakage, loosen and
re-tight
en this connection. If it still leaks,
please contact customer service on
Note: The Cylinder must be positioned as shown in the patio heater cylinder
chamber to provide vapour withdrawal.
Lantern
Support
Pole
Page 9
Points for leak testing
Hose / Regulator
Regulator / Cylinder
Connect
securely with
adjustable
wrenches
Screw regulator
onto gas
cylinder
Position
gas cylinder
inside cylinder
chamber
as shown
securing
with chain.
Secure lantern to top of the support pole with 4 of the bolts
washers
Connect the lantern hose to the regulator hose, and secure tightly with
adjustable wrenches. Then attach the regulator to the cylinder, turn
clockwise to tighten it securely. Place the cylinder in position as shown.
(F) and
[e-mail] or [phone] 2876
(E).