Installation Guide

5 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Maintenance
Replacing the battery
NOTE: Use one AA size, 400mAh, 1.2V Nickel Metal
Hydride rechargeable battery. For best performance,
replace with a Nickel Metal Hydride rechargeable
battery annually.
IMPORTANT: Dispose of the battery in accordance
with local, state, and federal regulations.
IMPORTANT: When storing any solar product for an
extended period of time, remove the batteries.
Storing any solar product without regular recharge or
removal of batteries could cause permanent damage
to the rechargeable batteries.
□ Hold the lamp housing (B), and rotate the top cap (A)
counter-clockwise until it is loose. Then, remove the
top cap (A) from the lamp housing (B).
□ Remove the battery cover (G) and the old battery (E).
Replace with a new Nickel Metal Hydride rechargeable
battery – The recommended replacement battery
capacity should be 400~600mAh.
□ Replace the battery cover (G). Place the top cap (A)
back on the lamp housing (B), and rotate the top cap
(A) clockwise until it locks in place.
A
E
G
B
Care and Cleaning
□ The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
□ Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Problem
Possible Cause
Solution
The nightly run
time is shorter.
The battery is not fully charged.
Ensure the solar light is located in an area
where it can receive the maximum amount of
full, direct sunlight every day. Keeping the solar
panel clean is equally important to ensure the
maximum charging performance.
The battery is reaching the end of its useful
life.
Replace the old battery with a Nickel Metal
Hydride rechargeable battery.
The solar light
does not turn on
at night.
Your solar light is inserted with a battery
isolator tag in the battery compartment. This
isolator tag must be removed prior to use.
Prior to use, check that the battery isolator tag
has been removed from the unit and the unit is
allowed to charge a full sunny day.
The solar light is installed close to other light
sources, which may keep the solar light from
turning on at night automatically.
Relocate the fixture or eliminate other light
sources.