Installation Guide

5 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Maintenance
1
Battery replacement
NOTE: Use one AA size, 900mAh, 1.2V Nickel Metal Hydride
rechargeable battery. For best performance, replace with a Nickel
Metal Hydride rechargeable battery annually.
IMPORTANT: Dispose of the battery in accordance with local,
state, and federal regulations.
IMPORTANT: When storing any solar product for an extended
period of time, remove the batteries. Storing any solar product
without regular recharge or removal of batteries could cause
permanent damage to the rechargeable batteries.
□ Rotate counterclockwise and remove the lamp housing (C) from the top cap (A).
□ Rotate counterclockwise and remove the glass shade (B) from the top cap (A).
□ Remove the battery compartment lid (H) from the battery compartment located on
the back plate of the top cap (A).
□ Remove the old battery (F). Replace with a new AA size, 1.2V Nickel Metal Hydride
rechargeable battery – The recommended replacement battery capacity should be
900~1200mAh.
□ Replace the battery compartment lid (H), and then replace the glass shade (B) and
the lamp housing (C) to the top cap (A) respectively.
Care and Cleaning
Periodic cleaning of the solar panel and glass housing is quick and easy:
□ The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
□ Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Problem
Possible Cause
Solution
The nightly run time is
shorter.
The battery is not fully charged.
Ensure the solar light is located in an area where it can
receive the maximum amount of full, direct sunlight every
day. Keeping the solar panel clean is equally important to
ensure the maximum charging performance.
The battery is reaching the end of its useful life.
Replace the old battery with a Nickel Metal Hydride (Ni-
MH) rechargeable battery.
The solar light does not
turn on at night.
Your solar light is inserted with a battery isolator tag in
the battery compartment. This isolator tag must be
removed prior to use.
Prior to use, check that the battery isolator tag has been
removed from the unit and the unit is allowed to charge a
full sunny day.
The solar light is installed close to other light sources,
which may keep the solar light from turning on at night
automatically.
Relocate the fixture or eliminate other light sources.