Use and Care Manual
4
Installation
Installing the light
IMPORTANT: Prior to use, remove the battery
isolator tag (F) from the battery compartment and
allow it to charge for a full sunny day.
NOTE: Do not use a hammer. If the ground is hard,
use water to soften.
□ Insert the ground stake (D) firmly into the ground at the installation location. If the ground is too hard, soak the
ground with water to soften the ground or drive a metal rod or screwdriver into the ground to create a hole for the
ground stake (D).
□ Connect the pole (C) to the ground stake (D).
□ Connect the lamp housing assembly (A & B) to the pole (C).