Manualshelf

Use and Care Manual

ManualsBrandsHampton Bay ManualsKitchenLyndhurst 52 in. Oil Rubbed Bronze Indoor Ceiling Fan
12345678910
10
Mounting the fan Close-to-Ceiling mounting
□ Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the slots,
and turn clockwise to lock the canopy (C) in place.
□ Firmly tighten the two mounting screws (II).
□ Install the two mounting screws (JJ) (save from Assembly Step
1 “Preparing for mounting” ) into the holes in the canopy (C) and
tighten rmly.
□ Install the decorative canopy ring (K) by aligning the ring’s slots
with the screws in the canopy (C). Rotate the ring counter-
clockwise to lock it in place.
8
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattached
until all four canopy screws are engaged and rmly tightened.
D
C
A
II
K
WARNING: The locking slots of the ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and rmly tightened.
D
C
A
II
K
□ Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock the canopy (C) in place.
Immediately tighten the two mounting screws (II) rmly.
□ Install the two mounting screws (JJ) (save from Assembly
Step 1 “Preparing for mounting” ) into the holes in the canopy
(C) and tighten rmly.
□ Install the decorative canopy ring (K) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
counterclockwise to lock it in place.
Assembly - Hanging the Fan (continued)
7
Wrapping the extra wire
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
NOTE: Follow this step ONLY if you did not cut the extra
length from the wires coming from the ceiling fan.
□ Gently wrap the excess wire around the mounting
bracket.
□ Secure the wires with electrical tape.