Use and Care Manual

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Fan Blades

Assembly - Attaching the Light Kit

Attaching the light kit

Attaching the glass shades

and bulbs

Attaching the fan blades

□ Remove the three screws (QQ) from the black bracket below

the fan motor assembly (D).

□ Connect the wires exiting the bottom of the motor assembly

(D) by connecting the molded adaptor plugs (SS) together.

□ Slide the switch cup light kit (E) and secure it to the black

bracket using the three screws (QQ) that were removed in

the rst step.

□ Insert the glass shade (I) into the glass holder by carefully

squeezing the steel tensioners (TT) on the light xture together.

□ Gently slide the glass shade (I) over the steel tensioners (TT).

Make sure the glass shade is fully inserted into the socket for

a secure t. Repeat for the remaining glass shades.

□ With the power off, install the light bulbs (J) (Max. 9.5 W,

provided) into the light bulb sockets.

□ Attach the pull chain extensions (GG) to the light pull chain and

fan pull chain.

□ Attach a blade (G) to a blade bracket (H) using the screws

(AA) provided. Please note that the rubber washers are

pre-attached to the blade bracket (H). Insert a screw into

the blade bracket (H). Repeat for the two remaining screws

(AA).

□ Tighten each screw securely.

□ Fasten the blade assembly to the motor by inserting the

alignment post into the slot on the bottom of the motor and

tighten the motor screws. Please note that the motor screws

are pre-attached into the blade arm.

□ Repeat steps 1-3 for the remaining blades.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

CAUTION: Make sure the power is off before attaching or

removing the glass shades.

WARNING: Allow the glass shade to cool completely before

removing.

NOTE: Your fan blades are reversible. Select the blade

side nish which best accentuates you decor.