Instructions / Assembly

11
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Light Kit
Attaching the light kit
Installing the bulbs and attaching
the glass bowl
11
12
□ Remove the four screws on the black bracket of the fan-
motor assembly (D).
□ Connect the wires exiting the bottom of the black bracket
with the light kit tter assembly by connecting the molded
adaptor connectors together.
□ Secure the light kit tter assembly to the black bracket using
the four screws that were removed in the rst step above.
□ Remove the nial and hex nut from the light kit tter
assembly.
□ With power off, install the three LED bulbs (K) (Max. 9.5W,
included) by screwing into the light bulb sockets.
□ Position the glass bowl (I) over the threaded nipple and pass
the pull chain (FF) for the fan through the pull chain guide
on the side of the light kit tter assembly to avoid the chain
from touching the glass bowl.
□ Re-install the hex nut to the threaded nipple to secure the
glass bowl (I) properly.
□ Re-install the nial.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light xture.
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
E
D
I
K
FF