Installation Guide

Assembly - Attaching the Light Kit

Attaching the light kit tter

assembly

Installing the glass shades

and bulbs

11 12

□ Loosen the three screws on the switch cup cover of the

light kit tter assembly (E).

□ Connect the to the light kit tter assembly (E) to the

wires from the switch cup of the fan motor assembly (D)

by connecting the molded adapter plugs together (blue

to black, white to white). Carefully tuck all wires and

splices into the switch cup.

□ Align the three screws on the switch cup cover of the

light kit tter assembly (E) with the three key slots in the

switch cup. Make sure the notch in the switch cup cover

of the light kit tter assembly clears the reverse switch

in the switch cup. Position the light kit tter assembly

(E) on the switch cup and turn clockwise until it locks.

Tighten the three screws that were loosened in the rst

step to secure the light kit tter assembly (E).

□ Remove the bottom cover and the nial from the light kit

tter (E).

□ With power off, install the three LED bulbs (J) by twisting

them into the light bulb sockets.

□ Position the glass bowl (I) and the bottom cover over the

threaded nipple and pass the fan switch chain through

the offset hole in the bottom cover.

□ Re-install the nial.

WARNING: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s reverse switch (RR).

This is the switch used to change the fan’s directional

rotation. For more information on the operation of this switch,

see Operating Your Fan on page 13.

CAUTION: Make sure the fan switch chain does not make

contact with the light bulbs.