Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Assembling The Fan Without The Light Kit

Operating your Fan

Turn on the power and check the operation of the fan. The pull

chain controls the fan speeds as follows:

1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off

The appropriate speed settings for warm or cool weather depend

on factors such as the room size, ceiling height, and number of

fans.

The slide switch controls the direction of the blades: forward

(switch down) or reverse (switch up).

Warm weather - (Forward) A downward airow creates a cooling ef-

fect. This allows you to set your air conditioner on a warmer setting

without affecting your comfort.

Cool weather - (Reverse) An upward airow moves warm air off of

the ceiling. This allows you to set your heating unit on a cooler set-

ting without affecting your comfort.

NOTE: Wait for the fan to stop before reversing the direction of

blade rotation.

WARNING: To reduce the risk personal injury. Do not bend the

blade holders while installing, balancing the blades, or cleaning

the fan. Do not insert objects between rotating blades.

Assembling the fan without

the light

□ In order to use the fan without the light kit, remove switch

cup cover from the top of the light kit tter assembly (E)

by removing center hex nut inside switch cup cover, and

then thread switch cup cover off of the threaded nipple on

the top of the light kit tter assembly (E). Remove three

screws.

□ Press plastic plug (EE) into the center hole of the switch

cup cover.

□ Align the three screw holes in switch cup cover with three

key slots in switch cup. Making sure the notch in switch

cup cover clears the reverse switch in switch cup.

□ Position switch cup cover onto the switch cup and install

the three screws that were removed in rst step. Turn the

switch cup cover clockwise until it locks and tighten the

three screws.