Installation Guide

8
Assembly - Hanging the Fan (continued)
Completing the fan assemblyMaking the electrical connection
□ Remove the two screws on two diagonal sides from
the top of the mounting plate (A) and loosen the
other two screws.
□ Align the two key slots on the top of the motor
housing (B) with the two screws on the mounting
plate (A). Push the motor housing (B) up and turn it
clockwise to lock in the mounting plate (A). Tighten
the two screws.
□ Install the two screws that were removed in at the
beginning of this step into the remaining two holes
and tighten the four screws rmly.
43
7
JJ
KK
LL
MM
LL KK
FF
C
A
B
□ Connect the green wire (MM) from the motor bracket to the
household wire using a plastic wire connector (CC).
□ Connect the fan motor white wire (LL) to the supply white
(neutral) (LL) wire using a the plastic wire connector (CC).
□ Connect the fan motor black (KK) and blue (JJ) wires to the
supply black (hot) wire (KK) using a plastic wire connector
(CC).
□ Spread the wires apart so that the green (MM) and white (LL)
wires are on one side of the outlet box (FF) and the black wire
(KK) is on the other side.
□ Turn the wire connectors upward and push the wiring into the
outlet box (FF).
IMPORTANT: Use the plastic wire connectors (CC) supplied
with your fan. Secure the connectors with electrical tape
and ensure there are no loose strands or connections.
WARNING: Each wire not supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.