Installation Guide

Assembly - Attaching the Light Kit

Attaching the light kit pan

Attaching the light kit

Installing the light bulbs and

glass bowl

12 13

□ Remove one screw (N) from the black bracket below the

fan-motor assembly (E). Loosen, but do not remove the

other two screws.

□ Attach the light kit pan (F) to the fan-motor assembly (E)

by securing them with the two screws (N) loosened in the

rst step. Push the light kit pan (F) up to engage the screw

heads in the screw slots and turn to secure. Re-install the

screw (N) removed in the rst step. Tighten each screw

rmly.

□ Remove one screw (P) from the light kit pan (F). Loosen, but

do not remove the other two screws.

□ Connect the blue wire exiting the bottom of the fan-motor

assembly (E) with the black wire from the top of the light kit

tter assembly (I).

□ Connect the white wire exiting the bottom of the fan-motor

assembly (E) with the white wire from the top of the light kit

tter assembly (I).

□ Attach the light kit tter (I) to the light kit pan (F) by securing

them with the two screws (P) loosened in the rst step. Push

the light kit tter assembly (I) up to engage the screw heads

in the screw slots and turn to secure. Re-install the screw (P)

removed in the rst step. Tighten each screw rmly.

□ With the power off, install the light bulbs (L) (Max. 14W,

provided) into the light bulb sockets.

□ Remove the nial (PP), hex nut (QQ), and rubber washer (RR)

from the threaded nipple (SS) of light kit tter assembly (I).

Place the threaded nipple through the centre hole of the glass

bowl (J). Re-install the rubber washer (RR), hex nut (QQ), and

nial (PP).

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

WARNING: Do not overtighten when installing the glass shade

into the light kit assembly. Allow the glass shade to cool

completely before removing.