Installation Guide

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

Hanging the fan

□ Pass the 120-Volt supply wires through the center hole in the

slide-on mounting bracket (A).

□ Install the ceiling mounting bracket on the outlet box by slid-

ing the slide-on mounting bracket (A) over the two screws (UU)

provided with the outlet box. If necessary, use leveling washers

(not included) between the slide-on mounting bracket (A) and the

outlet box. Note that the at side of the mounting bracket (A) is

toward the outlet box.

□ Securely tighten the two mounting screws (UU).

□ Carefully lift the fan-motor assembly (E) up to the slide-on

mounting bracket (A).

□ Seat the hanger ball portion of the ball/downrod assembly (B)

in the mounting bracket socket. Ensure that the tab on the

slide-on mounting bracket (A) socket is properly seated in the

groove in the hanger ball.

4 5

WARNING: To reduce the risk of re, electric shock

or personal injury, mount to outlet box marked

“acceptable for fan support of 35lbs. (15.9 Kg) or

less” and use screws provided with the outlet box.