Use and Care Manual
9
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Blade Brackets and Fan Blades
Attaching the blades to the blade
brackets
□ Fasten the blade brackets (H) to the fan-motor assembly
(B) by inserting the alignment post into the slot on the
bottom of the motor and tightening the pre-installed blade
bracket screws by inserting a screw driver through the
access hole (ZZ).
□ Repeat this step for the remaining blade assemblies by ro-
tating the motor until the next blade bracket screw can be
accessed through the access hole (ZZ) in the switch cup.
□ Mount the fan blades (G) to the blade bracket (H) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (H).
□ Hold the blade (G) close to the blade bracket (H) and press the
blade (G) down rmly. Ensure the key-slot holes are properly
seated on the blade arm posts.
□ While still holding the blade (G) down, rmly slide the blade
(G) away from the bracket (H) side until the blade (G) engages
in the locking mechanism. Make sure the locking mechanism
at the rear of the blade bracket (H) springs upward and
butts against the edge of the blade (G) indicating a secure
connection.
□ Visually inspect the top of the blade bracket (H) to ensure the
locking mechanism is securely in place.
□ Repeat for the remaining blades (G).
5
6
NOTE: Your fan blades are reversible. Select the blade side
nish which best accentuates your decor.
Fastening the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom
of the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for
quick and easy blade installation, including an alignment
post and captive blade bracket screws.
IMPORTANT: The switch cup has an access hole (ZZ) to
allow the screwdriver to reach the screws in the blade
bracket. Position the blade bracket on the motor and
tighten by inserting the screwdriver through the access
hole (ZZ).
B
H
ZZ
H
G