Instructions / Assembly

Installing the glass shades and bulbs

□ Insert the glass shade (F) into the light kit cowling and turn

the thumb screw (MM) clockwise to tighten and secure the

glass shade.

□ With power off, screw the LED bulbs (I) into the sockets.

□ Insert light and fan pull chain through each hole on the pull

chain guide.

□ Attach the pull chain extensions (AA) to the light pull chain

and fan pull chain.

CAUTION: Make sure the power is off before attaching or

removing the glass shade.

WARNING: Allow the glass shade to cool completely before

removing.

Assembly - Attaching the Light Kit Fitter Assembly

Attaching the light kit tter assembly

□ Remove the three screws (QQ) from the light kit tter

assembly (E).

□ Connect the wires exiting the bottom of the motor assembly

(B) by connecting the molded adaptor plugs together (blue to

blue, and white to white).

□ Slide the light kit (E) and secure it to the switch housing using

the three screws (QQ) that were removed in the rst step.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.