Instructions / Assembly

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Blade Brackets and Fan Blades

Attaching the blades to the blade

brackets

□ Fasten the blade brackets (H) to the fan-motor assembly (B) by

inserting the alignment post into the slot on the bottom of the

motor and tightening the pre-installed blade bracket screws by

inserting a screw driver through the access hole (ZZ).

□ Repeat this step for the remaining blade assemblies by rotating

the motor until the next blade bracket screw can be accessed

through the access hole (ZZ) in the switch cup.

□ Mount the fan blades (G) to the blade bracket (H) by aligning

the three key-slot holes in the blade (G) with the three posts

on the top of the blade brackets (H).

□ Hold the blade (G) close to the blade bracket (H) and press the

blade (G) down rmly. Ensure the key-slot holes are properly

seated on the blade arm posts.

□ While still holding the blade (G) down, rmly slide the blade

(G) away from the bracket (H) side until the blade (G) engages

in the locking mechanism. Make sure the locking mechanism

at the rear of the blade bracket (H) springs upward and

butts against the edge of the blade (G) indicating a secure

connection.

□ Visually inspect the top of the blade bracket (H) to ensure the

locking mechanism is securely in place.

□ Repeat for the remaining blades (G).

NOTE: Your fan blades are reversible. Select the blade side

nish which best accentuates your decor.

Fastening the blade brackets to

the motor

NOTE: Your fan features revolutionary advancements for

quick and easy blade installation, including an alignment

post and captive blade bracket screws.

IMPORTANT: The switch cup has an access hole (ZZ) to

allow the screwdriver to reach the screws in the blade

bracket. Position the blade bracket on the motor and

tighten by inserting the screwdriver through the access

hole (ZZ).