Users Manual

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(standard mount)

□ Align the locking slots of the canopy (C) with the two screws

(GG) in the mounting bracket (A). Push up to engage the slots

and turn clockwise to lock in place.

□ Firmly tighten the two mounting screws (GG).

□ Align the oval shape on the canopy (C) with canopy bottom

cover (HH), Push up the canopy bottom cover (HH) until the

screw (GG) heads engage to the slots on the canopy bottom

cover (HH) so that the magnetic canopy bottom cover (HH) can

be attached to the bottom of the canopy (C) properly.

WARNING: When using the standard ball/downrod mounting,

the tab in the ring at the bottom of the mounting bracket

must rest in the groove of the hanger ball. Failure to properly

seat the tab in the groove could cause damage to the wiring.

Installing the blades

□ Attach a blade (F) to the fan motor assembly (E) by inserting

the blade (F) into slots in the side of the fan motor assembly (E)

and aligning the three screw holes in the blade with the holes

in the center ywheel and secure with screws (FF).

□ Make sure all the screws are rmly tightened.

□ Repeat these steps for the remaining blades.

NOTE: The magnet is pre-attached on the canopy bottom

cover for you to remove and install easily.