Users Manual
7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Standard Ceiling Mount
Routing the wiresPreparing for standard mounting
□ Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
canopy bottom cover (HH).
□ Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□ Route the wires exiting the top of the fan motor assembly (E)
through the downrod (B) as shown.
21
□ Remove the magnetic canopy bottom cover (HH) from the
canopy (C) by pulling it off.
□ Loosen the two canopy screws (GG) located in the bottom of the
mounting bracket (A).
□ Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (C).
Assembling the fan
3
□ Loosen, but do not remove, the setscrews (KK) on the collar on
top of the fan-motor assembly (E).
□ Align the holes at the bottom of the ball downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□ Carefully insert the hanger pin (BB) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (BB) against the wiring inside the ball/downrod
assembly (B).
□ Insert the locking pin (CC) through the hole near the end of the
hanger pin (BB) until it snaps into its locked position.
□ Re-tighten the setscrews (KK) on the collar on top of the fan-
motor assembly (E).
B
BB
CC
KK
E
WARNING: Failure to properly install the locking pin (CC)
could result in the fan becoming loose and possibly falling.
A
GG
HH
C
C
D
HH
E
B