Installation Guide

ManualsBrandsHampton Bay ManualsKitchenSouthwind 52 in. Venetian Bronze Ceiling Fan Light

Table Of Contents

Assembly - Close-To-Ceiling Mounting

Assembly - Hanging the Fan

□ Remove canopy ring (K) from the canopy (C) by turning the

ring to the right until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the four screws on the top of the canopy (C).

Remove the two non-slotted screws and loosen the slotted

screws.

□ Remove the decorative canopy bottom cover (L) from the

canopy (C) by depressing the three studs.

□ Remove three of the six screws and lock washers (every

other one) securing the motor collar to the top of the fan

motor housing.

□ Place the rubber gasket (GG) over the remaining three

screws, route the wires exiting the top of the fan motor

through the canopy ring (make sure the slot opening are on

top), then proceed to place the ceiling canopy (C) over the

collar at the top of the motor.

□ Align the mounting holes with the holes in the motor and

fasten, using the three screws and lock-washers removed

previously. Tighten the mounting screws securely.

Attaching the fan to the electrical

box

Hanging the fan

□ Pass the 120-Volt supply wires through the center hole in the

mounting bracket (A).

□ Install the ceiling mounting plate on the outlet box by sliding the

mounting bracket (A) over the two screws (HH) provided with the

outlet box. If necessary, use leveling washers (not included) be-

tween the mounting bracket (A) and the outlet box. Note that the

at side of the mounting bracket (A) is toward the outlet box.

□ Securely tighten the two mounting screws (HH).

□ Carefully lift the fan motor assembly (D) up to the mounting

bracket (A).

□ Seat the hanger ball portion of the ball/downrod assembly (B)

in the mounting bracket socket. Ensure that the tab on the

mounting bracket (A) socket is properly seated in the groove

in the hanger ball. If using close-to-ceiling mounting, hang the

fan on the hook provided by utilizing one of the holes at the

outer rim of the ceiling canopy.

4 5

WARNING: To reduce the risk of re, electric shock,

or other personal injury, mount the fan to an outlet

box or supporting system marked acceptable for fan

support and use the mounting screws provided with

the outlet box.

WARNING: The hook as shown is only to balance fan

while attaching wiring. Failure to hang as shown may

result in hook breaking, causing the fan to fall. Hook

must pass from inside to outside of canopy.