Installation Guide

HAMPTONBAY.COM

Please contact 1-877-527-0313 for further assistance.

Assembly

Installing the downrod

□ Route the wires exiting the top of the motor housing (G)

through the downrod (B).

□ Insert the downrod (B) into the coupler (J) on the top of the

motor housing (G).

□ Align the holes at the bottom of the downrod (B) with the holes

in the coupler (J) and insert the hanger bolt (EE).

□ Secure the hanger bolt (EE) using the at washer (FF),

lockwasher (HH), and the hexagonal nut (GG).

□ Insert the split pin (NN) into the end of the hanger bolt (EE) and

split the ends of the split pin (NN) apart to secure the hanger

bolt (EE).

□ Tighten the set screw (ZZ) rmly.

Dismantling the ball/downrod

assembly

□ Loosen the hanger ball (H) by removing the set screw

(PP) and lockwasher (QQ) at the top of the downrod (B)

which holds the hanger ball to the downrod.

□ Slide the hanger ball (H) down the downrod (B) and

remove the support pin (RR).

□ Unscrew the green groundwire (I) located at the top of

the downrod (B) by unscrewing the screw (SS) on the

downrod (B).