Use and Care Guide

15
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Fan Blades
Attaching the blades
2
□ Mount the fan blades (G) to the blade bracket (H) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (H).
□ Hold the blade (G) with both hands close to the blade bracket
(H) and press the blade (G) down rmly. Ensure the key-slot
holes are properly seated on the blade arm posts.
□ While still holding the blade (G) down with both hands, rmly
slide the blade (G) away from the fan-motor assembly (E) until
the blade (G) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(H) springs upward and snaps into place against the edge of
the blade (G) indicating a secure connection.
□ Visually inspect the top of the blade bracket (H) to ensure the
locking mechanism is securely in place.
□ Repeat for the remaining blades (G).
H
G
Attaching the light kit tter assembly
1
□
Remove the three light kit mounting screws (RR) on the black
bracket below the fan-motor assembly (E).
□
Plug the molded adaptor plug from the light kit (F) to the
molded adaptor plug from the fan-motor assembly (E). Make
sure the connector latch close properly.
□
Align the holes in the light kit (F) with the holes in the black
bracket below the fan-motor assembly (E) and install using
the light kit mounting screws (RR) that were removed in the
rst step above.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light xture.
NOTE: Notice the location of the fan’s slide switch. This is the
switch used to change the fan’s directional rotation. For more
information on the operation of this switch, see Operating
Your Fan on page 17.
E
F
RR
NOTE: This light kit cannot be transferred to another fan.
Assembly - Attaching the Lights
IMPORTANT: It is critical to attach the light kit using the quick
connector. The fan will not operate unless the light kit is
connected to the fan.