Instructions / Assembly

5 HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Adjusting The Main Light and Night Light (continued)
Using the Main Light
□ Simply flip the wall switch “On” or “Off” for normal use.
Using the Nightlight with Motion Detection
□ When the last user double flips (within 3 seconds) the wall switch,
the fixture enters Nightlight Mode. The Nightlight turns on for
5 or 15 minutes (depending on user selection) after the last motion
is detected, then turns off.
□ During the night when the user walks into the room and motion is detected, only the nightlight fades on. The nightlight fades off after
the user leaves and the set time expires.
□ If the user wants the full light on, they simply flip the wall switch to exit Nightlight Mode.
NOTE: The user can choose to have the Nightlight on constantly when in Nightlight Mode by setting the Motion Sensor switch on the
back of the fixture to “Off”.
NOTE: Selecting “Off” for the motion sensor may be preferred depending on location of the light fixture to doorways or other
obstructions to the motion sensor.
Adjusting the Motion Sensor of The Night Light
□ Selecting “Off” disables the motion sensor and allows the Nightlight to remain on constantly when in Nightlight Mode.
□ Selecting “5” or “15” sets the length of time the Nightlight will remain on after the last detected motion.
Care and Cleaning
CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse
from the fuse box.
□ Clean the fixture with a soft, dry cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives.
□ Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.
Troubleshooting
WARNING: Before doing any work on the fixture, disconnect power to the light fixture.
Minor problems often can be fixed without the help of an electrician.
Problem Possible Cause Solution
The fixture will not light. The power is off. Ensure the power supply is on.
The circuit breaker is off. Ensure the circuit breaker is in the on position.
There is a bad connection. Check to ensure proper wire connections are made.
Contact a qualified electrician.
There is a defective switch. Contact a qualified electrician.
The fuse blows or the circuit breaker
trips when the light is turned on.
The wires are crossed or the power
wire is grounding out.
Check the wire connections.
Contact a qualified electrician or call Hampton Bay
customer service 1-855-HD-HAMPTON.
A
Switch for color choice
Switch for nightlight
detection time
2700K 3000K 5000K
Motion OFF / 5mins / 15mins