Instructions / Assembly
Attaching the housing
to the ceiling
■
Drill a 1/4 in. pilot hole into
the marked screw locations.
You can also use an awl or
nail to dimple the screw holes.
■
Start the screws (EE) but do
not tighten fully. Slide the
fixture (A) over until the
narrow legs of the keyhole
slots are under the heads of
the screws (EE).
■
Finish tightening the screws
(EE) until they are firmly
seated and the fixture (A) is
tightly secured to the
mounting surface.
4
Mounting to the housing
plate
■
Position the diffuser (B) over the
housing (A).
5
Closing the diffuser latches
■
Turn the diffuser latches (D) to the right
until they are closed.
■
Restore power to the electrical box. Turn
the light switch on to activate the fixture.
6
6
Installation (continued)
A
D
B
A
DD
EE
NOTE: The drywall anchors (DD) are only to be used for
mounting the fixture onto plaster or drywall surfaces.