Full Product Manual

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Fan Blades

Assembly - Hanging the Fan (continued)

Attaching the blade brackets

□ Fasten the blade bracket (I) to the motor (F) by inserting the

alignment post into the slot on the bottom of the fan-motor

assembly (F) and tightening the motor screws that are pre-

assembled to the blade bracket (I).

□ Repeat for the remaining four blade brackets (I).

Mounting the fan

(close-to-ceiling mount)

□ Carefully unhook the fan from the mounting bracket (A) and

align the locking slots of the ceiling canopy (C) with the two

screws in the mounting bracket (A). Push up to engage the

slots and turn clockwise to lock in place. Immediately tighten

the two mounting screws rmly.

□ Install the two mounting screws (FF) and lock washers (GG)

saved from Assembly Step 1 “Preparing for mounting” into the

holes in the canopy (C) and tighten rmly.

□ Install the decorative canopy ring (M) by aligning the ring’s

slots with the screws in the canopy (C). Rotate the ring

clockwise to lock in place.

WARNING: The locking slots of ceiling canopy are provided only

as an aid to mounting. Do not leave the fan assembly unattended

until all four canopy screws are engaged and rmly tightened.