Installation Guide
12
Installing the bulbs and glass bowl
2
□ Remove the nial (PP) and the bottom cover (OO) from the
threaded nipple of the light kit tter assembly (E).
□ With the power off, install the three LED bulbs (I) by screwing
them into the light bulb sockets.
□ Position the glass bowl (H), re-install the bottom cover
(OO) over the threaded nipple, and direct the fan pull chain
through the side hole of the bottom cover (OO).
□ Re-install the nial (PP) over the threaded nipple and direct
the light pull chain through the hole of the nial (PP), and
tighten the nial (PP) securely.
□ Attach the pull chain extensions (AA) provided to the light
pull chain and fan pull chain.
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
WARNING: Allow the glass bowl to cool completely before
removing.
Assembly - Attaching the Lights
Attaching the light kit tter assembly
1
□ Remove and save the three light kit mounting screws (MM) on
the black bracket below the fan-motor assembly (D).
□ Connect the wires from the light kit tter assembly (E) to the
wires from the fan motor assembly (D) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□ Align the three holes in the black bracket below fan motor
assembly (D) with the three holes in the switch cup of the light
kit tter assembly (E). Position the light kit tter assembly (E)
and re-install the three screws (MM) that were removed in rst
step to secure the light kit tter assembly (E).
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light xture.
NOTE: Notice the location of the fan’s slide switch. This is
the switch used to change the fan’s directional rotation.
For more information on the operation of this switch, see
Operating Your Fan on page 14.
D
E
MM
D
E
H
OO
AA
PP
I
IMPORTANT: It is critical to attach the switch cup using the
quick connector. The fan will not operate unless the light kit
is connected to the fan.