Instructions / Assembly

11
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Fan Blades
Fastening the blade brackets to
the motor
1
□ Fasten the blade brackets (G) to the fan-motor assembly
(D) by inserting the alignment post into the slot on the
bottom of the motor and tightening the pre-installed blade
bracket screws (LL).
□ Repeat this step for the remaining blade assemblies.
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation. Including an alignment post and
captive blade bracket screws.
D
G
LL
Attaching the blades to the blade
brackets
2
□ Mount the fan blade (F) to the blade bracket (G) by aligning the
three key-slot holes in the blade (F) with the three posts on the
top of the blade bracket (G).
□ Hold the blade (F) with both hands close to the blade bracket
(G) down rmly. Ensure the key-slot holes are properly seated
on the blade bracket (G) posts.
□ While still holding the blade (F) down with both hands, rmly
slide the blade (F) until it engages in the locking mechanism
(UU). Make sure the locking mechanism (UU) at the rear of the
blade bracket (G) springs upward and butts against the edge of
the blade (F), indicating a secure connection.
□ Visually inspect the top of the blade bracket (G) to ensure the
locking mechanism is securely in place.
□ Repeat this procedure for the remaining blades (F).
F
G
UU
NOTE: Your fan blades are reversible. Select the blade side nish
which best accentuates your decor.