Instructions / Assembly

Installing the bulbs and glass bowl

□ Remove the nial and the bottom cover from the threaded

nipple of the light kit tter assembly (E).

□ With the power off, install the three LED bulbs (I) by screwing

them into the light bulb sockets.

□ Position the glass bowl (H), re-install the bottom cover over

the threaded nipple, and direct the fan pull chain through the

side hole of the bottom cover.

□ Re-install the nial over the threaded nipple and direct the

light pull chain through the hole of the nial, and tighten the

nial securely.

□ Attach the pull chain extensions (AA) provided to the light

pull chain and fan pull chain.

CAUTION: Make sure the power is off before attaching or

removing the glass bowl.

WARNING: Allow the glass bowl to cool completely before

removing.

CAUTION: Do not over tighten the hex nut, overtightening the

hex nut may cause the glass bowl to break.

Assembly - Attaching the Lights

Attaching the light kit tter assembly

□ Remove and save the three light kit mounting screws (MM) on

the black bracket below the fan-motor assembly (D).

□ Connect the wires from the light kit tter assembly (E) to the

wires from the fan motor assembly (D) by connecting the

molded adaptor plugs together. Carefully tuck all wires and

splices into the switch cup.

□ Align the three holes in the black bracket below fan motor

assembly (D) with the three holes in the switch cup of the light

kit tter assembly (E). Position the light kit tter assembly (E)

and re-install the three screws (MM) that were removed in rst

step to secure the light kit tter assembly (E).

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s slide switch. This is

the switch used to change the fan’s directional rotation.

For more information on the operation of this switch, see

Operating Your Fan on page 14.

IMPORTANT: It is critical to attach the switch cup using the

quick connector. The fan will not operate unless the light kit

is connected to the fan.

CAUTION: Over lamping the fan will result in the fan lights

shutting down until the proper wattage bulbs are installed.

Reset the lights by turning off the power, replacing the bulbs

with the correct wattage bulbs, and turn the power on.