Instructions / Assembly
7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for standard mounting
□ Loosen, but do not remove, the setscrews (II) on the collar
on top of the fan-motor assembly (D).
□ Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□ Carefully insert the hanger pin (BB) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (BB) against the wiring inside the ball/
downrod assembly (B).
□ Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□ Re-tighten the setscrews (II) on the collar on top of the fan-
motor assembly (D).
□ Remove the canopy bottom cover (HH) from the canopy
(C) by turning the bottom cover counter-clockwise until it
unlocks.
□ Loosen the two canopy screws (GG) located in the bottom
of the mounting bracket, and turn the canopy counter-
clockwise to remove the mounting bracket (A) from
canopy (C).
□ Route the wires exiting the top of the fan motor
assembly (D) through the center of the canopy bottom
cover (HH).
□ Make sure the opening of canopy (C) are on top and
insert the ball/downrod (B) through the canopy (C).
□ Route the wires exiting the top of the fan motor
assembly (D) through the downrod as shown.
2
3
1
WARNING: Failure to properly install the locking
pin (CC) could result in the fan becoming loose and
possibly falling.
C
D
B
HH
D
B
BB
CC
II
C
B
HH
C
A
GG
HH