Instructions / Assembly

ManualsBrandsHampton Bay ManualsCeiling Fans52 in. Holly Springs Low Profile LED Brushed Nickel Ceiling Fan

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Blade Brackets and Fan Blades

Assembly - Attaching the Light Kit Fitter Assembly

Attaching the blades to the blade

brackets

Attaching the light kit tter assembly

□ Fasten the blade bracket (H) to the motor (B) by

inserting the alignment post into the slot on the

bottom of the fan-motor assembly (B) and tightening

the motor screws attached to the blade bracket (H).

□ Repeat for the remaining four blade brackets (H).

□ Remove the three screws (QQ) on the black bracket below the

fan- motor assembly (B).

□ Connect the wires from the light kit tter assembly (E) to the

wires from the black bracket below the fan-motor assembly (B)

by connecting the molded adaptor plugs together.

□ Carefully tuck all wires and splices in the switch cup.

□ Position the switch cup of the light kit tter assembly (E) on the

black bracket below the fan-motor assembly (B) and align the

three holes in the black bracket.

□ Re-install the three screws removed at the beginning of this

step to secure the light kit tter assembly (E).

□ Mount the fan blades (G) to the blade bracket (H) by

aligning the three key-slot holes in the blade (G) with the

three posts on the top of the blade brackets (H).

□ Hold the blade (G) close to the blade bracket (H) and

press the blade (G) down rmly. Ensure the key-slot

holes are properly seated on the blade arm posts.

□ While still holding the blade (G) down, rmly slide the

blade (G) away from the bracket (H) side until the blade

(G) engages in the locking mechanism. Make sure the

locking mechanism at the rear of the blade bracket (H)

springs upward and butts against the edge of the blade

(G) indicating a secure connection.

□ Visually inspect the top of the blade bracket (H) to ensure

the locking mechanism is securely in place.

□ Repeat for the remaining blades (G).

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

NOTE: Your fan blades are reversible. Select the blade side

nish which best accentuates your decor.

IMPORTANT: It is critical to attach the light kit using

the quick connector. The fan will not operate unless

the light kit is connected to the fan.

Fastening the blade brackets to

the motor