Installation Guide

Preparing the canopy

Preparing the motor

□ Remove the cotter pin (GG) and clevis pin (FF), and

loosen the two collar setscrews (HH) from the motor

collar.

Assembling the fan

□ Route the wires exiting from the top of the fan motor

assembly (E) through the canopy bottom cover (C).

Ensure the slot openings are on top.

□ Route the wires through the canopy (B) and then

through the hanger ball/downrod assembly (D).

□ Align the holes at the bottom of the hanger

ball/downrod assembly (D) with the holes in the collar

on top of the fan motor assembly (E).

□ Carefully insert the clevis pin (FF) through the holes

in the collar and the hanger ball/downrod assembly

(B). Be careful not to jam the clevis pin (FF) against

the wiring inside the hanger ball/downrod assembly

(D).

Assembly

□ Remove the canopy bottom cover (C) from the canopy

(B) by turning the canopy bottom cover (C) counter-

clockwise.

□ Remove the mounting bracket (A) from the canopy (B)

by removing the non-slotted canopy mounting screw

(EE) from the bottom of the canopy (B) and loosening

the slotted canopy mounting screw (EE) a half turn

from the screw head. Next, turn the canopy (B)

counterclockwise to remove the mounting bracket (A)

from the canopy (B).

WARNING: Failure to properly install the cotter pin (GG)

could result in the fan loosening and possibly falling.

NOTE: If a longer downrod is needed (not included), take

out the screw located in the hanger ball, lower the hanger

ball and remove the pin. Remove all three pieces from the

downrod, and assemble them onto the new longer downrod

before proceeding to the downrod installation.

□ Insert the cotter pin (GG) through the hole near the

end of the clevis pin (FF) until it snaps into the locked

position.

□ Tighten the two collar setscrews (HH) on top of the

fan motor assembly (E) ﬁrmly.