Use and Care Manual
Table Of Contents
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
Assembly and Installation
Attaching and installing the light
1
Item #1005 697 331
Model #62944
□ Detach and place the wire connector (D) on opposite sides of the low
voltage cable (not included) from the transformer (not included) where
the xture will be located.
□ Align and t the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (D) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact. Turn on the power unit. If the light xture does not
turn on, repeat operations 2 and 3.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
Option 1: Installing on 6 x 6 post
□ Put the xture head (A) with 6 x 6 adaptor (B) (pre-installed) on the 6 x 6
post and attach it with screws.
Connecting the wires
2
A - Fixture head
for 4 x 4 post
x 1
B - 6 x 6 adaptor
(pre-installed)
x 1
C - Connector
(attached to xture)
x 1
D - Connector with
96 inch wire length
x 1
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
IMPORTANT: Protect the wiring by routing it in close
proximity to the light or next to a building structure such as
a house or deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in order
to connect to the main secondary wire.
Do not submerge xtures in water.
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
E - Female connector
(connecting with D)
x 1
Option 2: Installing on 4 x 4 post
□ Remove the 6 x 6 adaptor (B) by loosening the screw on the adaptor.
□ Attach the 4 x 4 xture head on a 4 x 4 post.
D
A
B
C
D
E
F
F - Screw
x 2
□ Connect the male connector (C) with the female connector (E).
D
C
D
4 x 4 Post
6 x 6 Post
E
Use and Care Guide
LED Low Voltage Path Light
WARNING: Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.