Instructions / Assembly

11
Burner will not light using a match
No gas flow
Check if gas cylinder is empty. If yes, replace.
Regulator is not fully
connected to the
tank
Check LP tank connection.
Gas flow is obstructed
Check hose for bends or kinks
Spider webs or insect nest
in the venturi (end of
burner
tube)
Clean the venturi
Burner ports are clogged
Insert an opened paperclip into each of the burner ports to
clean
them. Ensure the appliance is off and all parts are cooled before
attempting to clean the burner ports
Appliance emits a lot of black smoke
when
lit
Flame is obstructed at
burner
ports
Make sure all the gas burner ports are free of any lava rocks or
debris to allow the gas to flow
freely.
Regulator hose is pinched
Check the regulator hose for bends or kinks
Sudden drop in gas flow
No gas flow
Check if gas cylinder is empty. If yes, replace.
Excess flow safety valve
has been
activated
Turn the control knob to "OFF", Close the LP tank valve and
disconnect the regulator from the tank. Turn the control knob
to
"HIGH". Wait 1 minute. Turner the control knob to "OFF".
Reconnect regulator to LP tank. Open tank valve slowly. Light
appliance as indicated in "To Light"
section.
Flame blow out
High or gusting winds
Increase flame to "High"
No gas flow
Check if gas cylinder is empty. If yes, replace.
Excess flow safety valve
has been activated
See "Sudden drop in gas flow" above
Irregular flame pattern or flame does not
come out of the entire length of the
burner
Burner ports are clogged See "Burner will not light using a match" above.
IF YOU HAVE QUESTIONS OR CONCERNS PLEASE CALL BOND TOLL FREE #
1-866-771-BOND (2663) OR TO BETTER EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
[e-mail]
OR LOG IN TO OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
www.bondmfg.com
BOND
MANUFACTURING CO.
1700 West 4th Street, Antioch CA 94509