Instructions / Assembly

7
ASSEMBLY INSTRUCTIONS
* Please keep these owner's manual for future reference.
*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3 directly.
STEP 1
.
(1) Open the carton and turn it upside down, make sure the 4 pieces of
the carton being open up as below.
(2) Lift off the carton carefully and be wary of the accessories inside falling away.
Take away the boxes containing lava rocks.
(3) Take all the packing materials away except for the polyfoam
rounding the top of the fireplace.
See Figure STEP
1.
STEP 2
(1) Turn the fireplace heads up on a flat ground.
(2) Cut off the binding tape on the polyfoam and remove all the
polyfoam rounding the top of the fireplace.
(3) Cut off the tie fastened the regulator at the metal stand and set it free for
installation to Pronane Tank.
See Figure STEP 2
STEP 3
(I) Attach the rear panel and 2pcs of decorative panel to the FRIM
pedestal using 2pcs M6 x 50 screw and 2pcs M6 nut.
(II) Attach the door assembly and 2pcs of decorative panel to the FRIM
pedestal using 2pcs M6 x 50 screw and 2pcs M6 nut.
(III) Attach the 2pcs of side panel to the rear panel and door assembly
using 8pcs M6 nut.
(IV) Attach the chimney to the rear panel and door assembly using 4pcs
M6 x 15 screw and 4pcs M6 nut
STEP 4
1) Check each part before using the product. Make sure the gas
supply system is turned "OFF" before assembling. See Figure I.
2) Locate the battery, remove the plastic cover first. Unscrew the
rubber cap of the Electric Ignitor; place a AAA battery into the
battery case. Make sure the positive pole ("+") towards the cap.
Screw the cap back to the battery case tightly. See Figure II
3) Place the lava rocks evenly in the fire bowl on the top of the
fireplace. See Figure III.
4) Put the gas tank in the metal stand. Make sure the gas tank sits on
the metal stand completely. Turn the wing screw on the outer part of
metal stand clockwise to secure the gas tank tightly.
See Figure IV & V
See "LP (Liquid Propane) gas
supply
connection" for tank
connection