Instructions / Assembly

3. OPERATING TRANSMITTER:
A. Install
12V MN21/A23 battery (included). To prevent damage to transmitter, remove the battery if not used for long periods. (Figure E)
B. Store the transmitter away from excess heat or humidity.
C. This remote control unit is equipped with 16 code combinations to prevent possible interference from or to other remote units such as
garage door openers, car alarm or security system. If you find that your fan and light kit go on and off without using your remote control,
simply change the combination code in your transmitter and receiver.
D. Operation buttons on the panel of the transmitter: (Figure F)
The " HI, MED, LOW" buttons:
These three buttons are used to set the fan speed as follows:
LOW= Low speed MED= Medium speed HI= High speed
The "OFF" button:
This button turns the fan off.
The" " button:
For fans that use incandescent bulbs, select “D” in the frequency switches, this” “button will control the light brightness. Hold the” “
key down to increase or decrease the light. Tap the” “key quickly to turn the light off or on. If you press the button in excess of 0.7
seconds it becomes a dimmer. The light varies cyclically in 0.8 seconds. The light key has auto resume, so it will stay at the same brightness
as the last time it was turned off.
For fans that use Fluorescent or LED bulbs, select “ON” in the frequency switches, this button will control the light ON/OFF only.
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND LIGHT.
4. TROUBLESHOOTING GUIDE
A. Fails to operate:
a. Power to the receiver?
b. Receiver wired correctly?
c. Fan manual speed control in highest position?
d. Light kit switch turned on?
e. Good battery in the transmitter?
f. Code set at exact same position in both transmitter and receiver?
B. Won't operate at distance: .
If transmitter operates the fan and the light kit when up close, but not a 30 feet away, try placing the black antenna wire higher; up through
the ceiling, outside the junction box.
NOTICE!
Your ceiling fan and light kit assembly must meet the following requirements:
1. Do not use with solid state fans.
2. Electrical rating: 120V / 60 Hz
MAX. motor amps:1.0 A
MAX. light watts: 300 W
Fig. E
Fig. F
If there are wires with different colors, have this unit installed by a qualified electrician.
e. Push all connected wires up into junction box.
f.
Reinstall the canopy on the mounting bracket.
g. Restore the electrical power.
Distributed by Home Depot U.S.A., Inc.
2455 Paces Ferry Rd. N.W.
Atlanta, Georgia 30339
TOLL FREE 1-877-902-5588