Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Installation - New Construction (continued)

Securing suspensions brackets onto fan

housing

 Secure suspension brackets (G, H) to the fan housing (A)

using the two machine screws (D) and secure suspension

bracket (F) to the other side of housing using the short

machine screw (E).

Removing wiring cover on the fan housing

Quick

Connector

Product

Wires

House

Wires

 Remove the wiring cover. Pull the house wires through the

wire box cover hole (5.1). Using the quick connector, secure

120 V AC house wiring from the wall switch to the fan as

shown in the wiring diagram on page 3. 14 AWG is the small-

est conductor that should be used for branch circuit wiring.

 Carefully push the connected wires back into the wiring box

housing. Reattach the wiring box cover (5.1).

CAUTION: If the electrical wires do not match the colors

listed, you must determine what each house wire represents

before connecting. You may need to consult an electrical

contractor to determine safely.

Connecting the duct

 Connect a 6 in. circular duct (not supplied) and vent to the

outside. Secure it with duct tape (not supplied) or a clamp (not

supplied) to make the connection secure and air tight.

 Turn on the power source. Check the fan for any abnormal

sound or vibration.

Installing the grille

 Attach the grille (B) by pinching the mounting springs and

inserting into the narrow rectangular slots in the fan housing (A).

G, H

5.1