Instructions / Assembly

Assembly Instructions
Locate and unpack table top. Place 1.
it bottom side up on a non-abrasive
surface along with the table legs.
Verify all parts are present using the
parts list. Remove the protective
plastic caps covering the four
threaded studs.
Attach one leg to the leg connector 2.
ring using two M6 Socket Head Cap
Screws. Do not tighten hardware
completely.
Attach the three remaining legs 3.
using the rest of the Socket Head
Cap Screws.
Turn the completed leg assembly 4.
upside down and position over the
table top. Align the slotted holes in
the legs with the studs on the table
top. Adjust the base if necessary to
center it over the table top.
Place one washer and one nut 5.
on each stud and use the 10 mm
wrench to tighten the nuts. Use the
5 mm Allen Wrench to tighten the
Socket Head Cap Screws in the leg
connector ring. Do not over tighten
hardware.
With the help of another person 6.
turn the table into the upright
position. Your table is now ready
for use.
Fold One
Fold One
Fold TwoFold Two
Instruction Sheet - 235 Series Tables R-03.indd 2 3/15/2011 5:35:04 AM